mohon bantuannya jgn dipermainkan poin besar membuat dialog prosedur text kalimat dibawah ini -First we will grind the front of this HSS rod (the yellow part of
B. inggris
yuanandrian12
Pertanyaan
mohon bantuannya jgn dipermainkan poin besar
membuat dialog prosedur text kalimat dibawah ini
-First we will grind the front of this HSS rod (the yellow part of the model above). Use a coarse grinding wheel. Position the chisel slightly to the left 10-15 degrees. This will create an angle of liberation, so that not all chisel parts come into contact with the workpiece later.
- The process of scratching makes the chisel become hot, so we need to occasionally mencelubkan to the coolant for about 15 seconds.
- The third step, we will makethe angle of discharge on the top side, the model is shown in blue. In this step, we must be more careful, donot let the side of the cut is the meeting of the left and top, swept grinding stone. If it happens then the height of the cut side will be reduced or lower than the body of the chisel itself, can still be used indeed, but may require additional platter plate when setting.
- The fourth or final step is to round off the ends of the pieces. For normal lathe tasks, the edge of the cut side is too sharp like the picture above will not last long. Therefore we must make it has a small radius to be used in deep enough food.
membuat dialog prosedur text kalimat dibawah ini
-First we will grind the front of this HSS rod (the yellow part of the model above). Use a coarse grinding wheel. Position the chisel slightly to the left 10-15 degrees. This will create an angle of liberation, so that not all chisel parts come into contact with the workpiece later.
- The process of scratching makes the chisel become hot, so we need to occasionally mencelubkan to the coolant for about 15 seconds.
- The third step, we will makethe angle of discharge on the top side, the model is shown in blue. In this step, we must be more careful, donot let the side of the cut is the meeting of the left and top, swept grinding stone. If it happens then the height of the cut side will be reduced or lower than the body of the chisel itself, can still be used indeed, but may require additional platter plate when setting.
- The fourth or final step is to round off the ends of the pieces. For normal lathe tasks, the edge of the cut side is too sharp like the picture above will not last long. Therefore we must make it has a small radius to be used in deep enough food.
1 Jawaban
-
1. Jawaban vierifirdausyp5k2yz
Who is playing football manager handheld Blackberry tipe slider storm Queen look right through the day